WireFlow Product Support Portal

General 9

• Can I use Scan Engine?
• What kind of connectors are used on WireFlow's modules?
• How much FPGA resources does a C-Series module consume?
• Is this C-series module compatible with cDAQ-systems from NI?
• Can I use WireFlow's modules with Veristand?

View all 9

WF 3132 Multiplexer Module 4

• Is it possible to use inductive loads together with the WF 3132?
• Is it possible to get 1500 samples/s with cDAQ?
• How can I use WF 3132 for thermocouple multiplexing
• Installation of cDAQ driver fails in LV2023/2024

WF 3144 Programmable Resistor Module 7

• Can I use the WF 3144 to simulate a PT-100 sensor?
• Can I use the WF 3144 to simulate an NTC Thermistor?
• What is the resolution of the WF 3144?
• Can I use the WF3144 to simulate a PT-1000 sensor?
• Can I set a higher resistance than 160kOhms for a channel

View all 7

WF 3168 Battery Stack Monitor and Balancing Module 3

• Is the sample rate specified for full configuration?
• Are all measurements taken simultaneously?
• What should I do if I have fewer battery cells than channels on the WF3168 or WF3169 module?

WF 3169 Battery Stack Monitor Module 3

• Is the sample rate specified for full configuration?
• Are all measurements taken simultaneously?
• What should I do if I have fewer battery cells than channels on the WF3168 or WF3169 module?